Tell us about the property and the problem. We’ll follow up to schedule a site visit.
Commercial Property Services
Commercial HVAC Service & Repair
Rooftop units, split systems, and the preventive work that keeps them off the emergency list.
No-heat and no-cool response, scheduled maintenance agreements, and straight answers on repair versus replacement. Commercial property across the Midwest since 1996.
Why it matters
An hour of no cooling is a tenant call
HVAC is the system that turns a maintenance issue into a lease issue fastest. A failed unit becomes a tenant complaint within the hour, and in a Midwest July or January it can become a habitability and liability problem for an occupied building.
It is also the equipment most likely to fail on the worst possible day, because that is the day it finally goes under full load — along with every other unit in the region.
That timing is the whole argument for maintenance agreements. A failing capacitor, a clogged condensate line, or a corroded contactor found in April is a scheduled, inexpensive repair. The same part found on the first ninety-degree day is an emergency call, competing with every other building that just discovered the same thing.
We service and repair commercial rooftop units, split and packaged systems, controls, and ventilation. And we will tell you plainly when a unit is worth repairing and when you are putting the most expensive component in the cabinet into equipment whose other parts are the same age.
Because we maintain the whole building, the problems that sit between trades do not get passed around. Water staining under a rooftop unit is the classic one — it is a condensate or curb-seal issue, and it involves both the unit and the roof.
What we see most
Common commercial HVAC problems
Several of these have the same symptom at the thermostat and completely different repairs behind them.
Call 309-796-2222Usually zoning, balancing, or a failed damper — not a broken unit. A west-facing suite with glass behaves nothing like an interior one on the same system.
Low charge, restricted airflow, a failing contactor, a control fault, or a unit undersized for how the space is used now. Each is a different repair at a very different price.
Starting and stopping repeatedly is hard on the compressor — the single most expensive component in the cabinet — and it quietly raises your energy cost every month.
Usually a condensate drain or a curb seal never resealed after service. It damages the roof above and the ceiling below while it gets passed between trades.
Dirty coils, failing components, and low charge all make equipment work harder for the same result. The bill usually notices before anyone else does.
Several repairs in a season is a signal worth taking seriously. At some point the repair spend passes what replacement would have cost.
What we do
Commercial HVAC services
Service, repair, replacement, and the roof and electrical work that comes with it.
Call 309-796-2222- RTU diagnosis and repair
- Compressor, condenser, and evaporator work
- Blower motors, belts, and bearings
- Heat exchanger inspection and repair
- Unit replacement and new installation
- Curb work, crane coordination, and resealing
- Economizer repair and adjustment
- Gas heat section service
- Split system service and repair
- Mini-split and ductless systems
- Server and equipment room cooling
- Unit heaters and infrared heat
- Make-up air units
- Refrigerant leak detection and repair
- Condensate drains and pumps
- Coil cleaning and restoration
- Thermostat and control troubleshooting
- Zoning and damper repair
- Air balancing and airflow correction
- Ductwork repair and modification
- Diffusers, grilles, and registers
- Programmable and setback scheduling
- Electrical disconnects and circuits
- Safety and limit controls
- Exhaust fan repair and replacement
- Kitchen and hood exhaust
- Restroom and locker room ventilation
- Warehouse and shop ventilation
- Building pressurization issues
- Louvers, dampers, and intakes
- Filter systems and upgrades
- Indoor air quality improvements
Maintenance agreements
Find it in April, not in July
Scheduled visits before each season puts the equipment under load. The point is not the filter change — it is catching the part that was going to fail anyway, while it is still a scheduled repair.
Before cooling season — coils cleaned, charge checked, condensate lines cleared, electrical connections tightened, belts and capacitors inspected.
Before heating season — heat exchangers inspected, burners and ignition checked, safety controls tested, filters and airflow confirmed.
Every unit, every visit. You get a record of what each unit is doing and what is coming, which is what makes capital planning possible.
Set to how the building actually runs rather than a generic calendar. Dusty environments and kitchens need a different interval than an office.
When a heat wave takes out units across the region, agreement customers are already on the schedule rather than joining the back of the queue.
Known service cost and advance warning on replacements beats an unplanned five-figure emergency in the middle of a season.
The real question
Repair the unit or replace it?
Age alone is a poor test. What failed, what else on that unit is the same age, and what it costs to run are the things that actually decide it.
- The failure is a motor, contactor, capacitor, or board
- The cabinet, coils, and heat exchanger are sound
- The unit holds charge and has no history of leaks
- Energy use is in line with what it should be
- It is the first significant repair on that unit
- Remaining service life justifies the part cost
- Compressor or heat exchanger failure on an older unit
- Repeated repairs across a single season
- A large refrigerant loss on aging R-410A equipment
- Cabinet or coil corrosion is advanced
- Energy cost has climbed with no change in use
- Repair spend is approaching replacement cost
Worth knowing
Refrigerant is now part of the math
If you own commercial equipment, the refrigerant transition has quietly changed how repair-versus-replace decisions work, and most building owners have not been told.
Under the AIM Act, production of HFC refrigerants including R-410A is being stepped down over time. New equipment has been shifting to lower-GWP A2L refrigerants such as R-454B and R-32, with commercial equipment categories following their own schedule rather than the residential one.
Three practical consequences for a building owner:
You can still service what you have. Existing R-410A equipment remains legal to service. Nothing forces you to replace a working unit.
R-410A gets scarcer and costlier. As production allowances fall, the refrigerant in your existing units is expected to become more expensive. A large charge loss on an old unit reads differently than it did five years ago.
Retrofitting generally is not an option. Manufacturers typically do not support converting an R-410A unit to run R-454B. The practical choice is to keep servicing it or replace it, not to convert it.
None of that means panic. It means that on aging equipment with a history of leaks, the replacement conversation deserves to happen on your schedule and your capital plan rather than during a July failure.
Rules, dates, and equipment categories continue to change. We confirm the current position for your specific equipment rather than working from a rule of thumb — and we will tell you when the honest answer is that your unit is fine.
Why West Maintenance
Why property managers call us for HVAC
Curb seals, condensate, and the staining below a unit stop being somebody else’s problem when one company handles both.
We show you the comparison, including when the honest answer is the smaller invoice and the unit has years left.
Spring and fall service with a written report per unit, so failures get found before the season, not during it.
Tenants, patients, and customers in the building while we work. We schedule and stage accordingly.
Since 1996 here. Equipment that has to deliver in a January cold snap and a July heat wave fails in predictable ways, and we know them.
Single sites and multi-location portfolios on one account, one contact, and one consistent standard.
How we work
Three steps from down to running
No agreement required to call. Plenty of accounts start with one dead unit.
Call 309-796-2222The property, how many units are on it, and what the thermostat is doing. Occupied buildings without heat or cooling get prioritized.
What actually failed, what it costs to fix, and — where it is close — how that compares against replacing the unit.
The repair, plus a written condition note on the unit so you know what is coming before it arrives.
Common questions
Commercial HVAC FAQs
Not covered here? Call and ask — we would rather answer it on the phone than have you guess.
Call 309-796-2222My building has no heat / no cooling. How fast can you get out?
Call 309-796-2222. A building that has lost heating or cooling is a tenant problem within the hour and a lease problem within the day, and in a Midwest January or July it can become a habitability and liability issue for an occupied building.
These move faster by phone than through a form. Tell us the property, roughly how many units are on it, and what the thermostat is doing.
Should I repair or replace a rooftop unit?
Age alone is a poor test. What matters is what failed, what it costs to fix, what else on that unit is near the end of its life, and what the unit is costing you in energy while it limps along.
A compressor or heat exchanger failure on an aging unit usually tips toward replacement, because you are putting the most expensive component into a cabinet whose other parts are the same age. A blower motor, contactor, or control board on the same unit is normally worth repairing.
The refrigerant in the unit is now part of that math too — see the refrigerant question below. We will show you the comparison rather than just recommending the bigger invoice.
What does a commercial HVAC maintenance agreement cover?
Scheduled visits — typically spring and fall, before the cooling and heating seasons put the equipment under load. Filters, belts, coils, drains, electrical connections, refrigerant charge, safety controls, and a written condition report on each unit.
The point is not the filter change. It is catching the failing capacitor, the clogged condensate line, and the corroded contactor in April rather than on the first ninety-degree day when every contractor in the region is booked.
How often should commercial HVAC be serviced?
Twice a year covers most commercial properties — once before cooling season and once before heating season. Equipment in dusty environments, kitchens, or heavy-use buildings often warrants quarterly.
Filters usually need changing more often than the service interval. We set a schedule that matches how the building actually runs rather than a generic calendar.
Who is responsible for HVAC — the landlord or the tenant?
It depends on the lease. Under a triple-net lease the tenant commonly carries HVAC maintenance and repair for their own unit. Under a gross lease the landlord usually does. Modified gross leases split it, and frequently the split puts routine maintenance on the tenant and major replacement on the landlord — sometimes with a dollar cap per occurrence.
We work for whichever party holds the obligation, and we are used to scoping repairs so it is clear which side of that line each item falls on. That matters when a repair sits near a cap.
What is happening with R-410A refrigerant?
Under the AIM Act, production of HFC refrigerants including R-410A is being stepped down over time. New equipment has been shifting to lower-GWP A2L refrigerants such as R-454B and R-32, with commercial equipment categories following their own schedule rather than the residential one.
What this means practically for a building owner: existing R-410A equipment can still legally be serviced, but as production allowances fall, R-410A is expected to get scarcer and more expensive. Manufacturers generally do not support retrofitting an R-410A unit to run R-454B.
So the refrigerant becomes a real input to repair-versus-replace decisions on aging equipment — a large charge loss on an old R-410A unit reads differently than it did five years ago. Rules and dates vary by equipment category and continue to change, so we confirm the current position for your specific equipment rather than working from a rule of thumb.
Why are some suites hot and others cold?
Usually zoning, balancing, or a failed damper rather than a broken unit. Buildings that were subdivided for tenants often have one unit serving spaces with very different loads — a west-facing suite with glass behaves nothing like an interior one.
It can also be a unit that is simply undersized for how the space is used now, which happens when a space changes occupancy. The fix is cheap or expensive depending on which it is, so it is worth actually measuring rather than adjusting thermostats and hoping.
Why does my unit run constantly?
Continuous run and short-cycling both mean the system is not reaching or holding setpoint, and both drive up energy cost while shortening compressor life.
Common causes are low refrigerant charge, a dirty coil or filter restricting airflow, a failing contactor or capacitor, a control or thermostat fault, or a unit that is undersized for the current load. Each one is a different repair at a very different price.
Is water staining near a rooftop unit an HVAC problem or a roof problem?
Often both, and that is exactly why it gets passed back and forth between contractors. It is usually a condensate drain problem or a curb seal that was never properly resealed after the unit was last serviced or replaced.
We handle the unit and the roof, so it gets diagnosed and fixed instead of each trade pointing at the other. See roof repair.
Do you install new rooftop units?
Yes — replacement and new installation, including the curb work, crane coordination, electrical, and the roof resealing that goes with it. Equipment lead times on commercial units can be long, so replacement is worth planning before the unit fails rather than after.
If you have units you know are near the end, a condition assessment now gives you real numbers for next year's capital budget.
Do you work on exhaust and make-up air?
Yes — exhaust fans, make-up air units, and ventilation for kitchens, shops, restrooms, and warehouse space. These get ignored until something fails or an inspection flags them, and they affect both comfort and how the building pressurizes.
Related services
Often handled on the same visit
Rooftop work touches the roof and the ceiling below it. Those go on the same bid.
All ServicesRequest a bid on commercial HVAC
Tell us about the property and what the equipment is doing. We’ll follow up to schedule a site visit.
309-796-2222- We walk the site and assess the actual condition.
- You get a priced scope before any work starts.
- Emergency? Call the number above instead of filling this out.
Send the details and we’ll be in touch to schedule a site visit.